E6s-8 Wiring Diagram?
 

Does anyone have it? I have to go over some of the wiring and i dont have the diagram availible.... thanks

This is just an E6S, the -8 just makes it setup for 8 low imp. injectors with its high current injector drivers enabled.

www.haltech.com , download section, the E6S diagram is right there.

Now, the problem with wiring up an E6S onto an FC is the following, depending on what firmware is in the unit you might not be able to read off the stock reluctors inside the CAS. You will need to either get a Haltech reluctor adapter (RA10) or a pair of MSD-8509 boxes, and you will also may not be able to connect it the way the stock FC ignition system works.

What you could use is a set of 4 LS1 coils which will allow you to run wasted spark with good results and not worry about the stock ignition system. Now, the E6S had only so many outputs that all will be taken up when you connect it all, unlike with the E6K/X that had 4xPWM outputs to let you connect other auxiliar options.

ha problem solved... i got the msd boxs :) thanks