Haltech Connecting Coolant/Water sensors...pins

Reply Subscribe

Thread Tools

Search this Thread

Jun 6, 2005 | 09:13 PM

Wankel7

Thread Starter

Haven't we ALL heard this

Joined: Mar 2001

Posts: 3,948

Likes: 1

From: Indiana

Connecting Coolant/Water sensors...pins

Well, I really made life harder for my self when I was installing the pins into the connector.

I could not figure out why the pins would not fit into the back of the connector. I eventully made it fit

However, it was supposed to fit like this. Wire slides thru the connector then the pin is crimped on. Then you pull wire/pin thru the connector.

Just thought I would pass this on...

I am sure I am not the first person to do this

At least I hope....

James

Jun 6, 2005 | 09:16 PM

Project84

Open up! Search Warrant!

Joined: May 2002

Posts: 3,838

Likes: 3

From: Kicking down doors in a neighborhood near you

I screwed one up too when I put my harness together.

Jun 6, 2005 | 09:21 PM

Wankel7

Thread Starter

Haven't we ALL heard this

Joined: Mar 2001

Posts: 3,948

Likes: 1

From: Indiana

Yes another is out there

Man, it took some crimping, cutting, and bending but those little pins WILL go in the wrong way

James

Jun 7, 2005 | 07:51 PM

Claudio RX-7

EFI Tech Wannabe

iTrader: (1)

Joined: Sep 2003

Posts: 2,415

Likes: 10

From: D.R., USA, the world...

Quote:

Originally Posted by Wankel7

Yes another is out there

Man, it took some crimping, cutting, and bending but those little pins WILL go in the wrong way

James

Believe me, i ALWAYS have spare temp connector pints because of that. They do go in the worng way but they'll slide right throuhg and you'll have to either try again or get a new pin, they also kinda "click" when you put them in right.

Its a dirty job but someone's gotta do it.