Haltech 2000rs pinout
#1
It wasn't me!!
Thread Starter
iTrader: (1)
Join Date: May 2004
Location: Cayman Islands
Posts: 1,189
Likes: 0
Received 0 Likes
on
0 Posts
2000rs pinout
Well Guys, I'm trying to finish up my haltech install, which is taking forever. I have a slight problem of tapping the haltech connections into my wire harness due to having a 2000rs model. I can not find jack **** on the ecu pinout for this car. I can find everything else for the 1993-1995 rx7 but not for mine .
I am looking for the one wire that goes back to the ecu connector for the electric fans and the other wire for the a/c. Does anyone know how to tone the wires so that I can find the right one on the pin connector?
BTW, Can someone explain the a/c setup if I want to use the haltech to control it? I'm all over the place with that too.
And if by some mericle, does anyone have a scematic for the 2000 model rx?? That would help.LOL
THANKS A BUNCH!!
I am looking for the one wire that goes back to the ecu connector for the electric fans and the other wire for the a/c. Does anyone know how to tone the wires so that I can find the right one on the pin connector?
BTW, Can someone explain the a/c setup if I want to use the haltech to control it? I'm all over the place with that too.
And if by some mericle, does anyone have a scematic for the 2000 model rx?? That would help.LOL
THANKS A BUNCH!!
Thread
Thread Starter
Forum
Replies
Last Post
windom
Adaptronic Engine Mgmt - AUS
4
09-11-15 04:48 AM