We've had a few requests to make a new run of these available recently... so here it goes. We're doing a small production run of oil filter pedestals which will be shipping in the next two weeks. Currently about half of our 30 piece production run has been pre-sold but for those who are not aware, here is some more information on our pedestal/adapter:




Currently we are taking pre-orders for $160.00

(Retail pricing will be $175 after the pre-sale is over for any remaining inventory)

Originally we made this for our own cars a few months back and have been running it for some time now (picture from test fitting). It's shorter than the stock pedestal to give a little extra room when running the "tall" filter element for better filtration (we use the Mazda 929 filter on our cars), has two 1/8" NPT ports for pressure/temp gauges, as well as a 3/8" NPT port for either a GM type temp sensor, or as an optional feed for the center iron. We machine it out of a single piece of billet as we've seen the damage some of the welded or two piece threaded filter posts have done.


We include new viton o-rings for the base and plugs for any unused ports. This can be used with the stock banjo hard-line for the oil cooler or a -10AN adapter if used with our oil cooler kit or aftermarket DIY setup. We sold out of the handful we made originally but should have more in stock in the next couple weeks.


Highlights:
•Shorter than stock - for taller filters
•One piece billet construction
•2x 1/8" NPT sensor ports
•1x 3/8" NPT sensor/feed port
•Viton O-rings
•Stainless hardware and port plugs


To pre-order please click the following link->
FD3S: Billet CNC Oil Filter Pedestal - SakeBomb Garage LLC



Pre-Sale List:
0. SBGarage - no AN fitting - PAID
1. pre-sold
2. pre-sold
3. pre-sold
4. pre-sold
5. pre-sold
6. pre-sold
7. pre-sold
8. pre-sold
9. pre-sold
10. pre-sold
11. pre-sold
12. pre-sold
13. pre-sold
14. pre-sold
15. pre-sold
16. pre-sold
17.
18.
19.
20.
21.
22.
23.
24.
25.
26.
27.
28.
29.
30.
-Full-