FD OLED odometer screen Replacement
sorry to everyone if I've miss3d your messages...yall can check this out i dont get on the forums every day like i used too haha
Www.rxclusterworx.com
Www.rxclusterworx.com
Newbie
Joined: Feb 2023
Posts: 4
Likes: 1
From: Leiria
Fd oled
Hey Everyone! A lot of you know I have been repairing Odometer screens on the FD for quite a while and have repaired around 300 of them for people so far. I currently schedule out about 5 a week just due to capacity reasons as my main line of work keeps me pretty busy. I did the original development on this by reverse engineering the board circuitry for a larger manufacturer, and Found most of the issues with the screen at this point. Still there have been some boards where the onboard processor has dies and cannot at this point be replaced. So I set out for an alternate solution And came up with the idea for replacing the process or and screen altogether with a much more updated version:
Behold! the Oled odometer screen which opens the door to many new possibilities including a digital read out of the odometer in both metric and imperial units AND a digital readout for Speed! Longer term will also include readouts for boost, and other features including a can bus input option for those with aftermarket ECUs. I am approaching the project in phases. Phase 1 will include just a drop in replacement for the odometer screen retaining your mileage with a digital speed readout as well. I am 90% complete on this phase already. The various screens will be toggled through using the factory trip reset stick and a 3 second hold of the reset stick will reset the trip. I hope to be installing these towards the end of summer. Phase 2 will include the can bus option. phase 3 will likely be a complete drop in replacement for the speedo board to a digital speedo unit!
Below are some pictures as to where i stand so far. The programming for phase 1 is complete and just needs to be compiled for the correct processor. From there i will just need to perform longer term testing to workout any obvious bugs in the firmware.
Behold! the Oled odometer screen which opens the door to many new possibilities including a digital read out of the odometer in both metric and imperial units AND a digital readout for Speed! Longer term will also include readouts for boost, and other features including a can bus input option for those with aftermarket ECUs. I am approaching the project in phases. Phase 1 will include just a drop in replacement for the odometer screen retaining your mileage with a digital speed readout as well. I am 90% complete on this phase already. The various screens will be toggled through using the factory trip reset stick and a 3 second hold of the reset stick will reset the trip. I hope to be installing these towards the end of summer. Phase 2 will include the can bus option. phase 3 will likely be a complete drop in replacement for the speedo board to a digital speedo unit!
Below are some pictures as to where i stand so far. The programming for phase 1 is complete and just needs to be compiled for the correct processor. From there i will just need to perform longer term testing to workout any obvious bugs in the firmware.
Thanks
Thread
Thread Starter
Forum
Replies
Last Post
Gen2n3
3rd Generation Specific (1993-2002)
112
Apr 16, 2025 01:34 PM