General Rotary Tech Support Use this forum for tech questions not specific to a certain model year
Sponsored by:
Sponsored by: CARiD

Starting Problems... ECU?

Old Apr 25, 2008 | 07:15 PM
  #1  
91' RX-7 Vert's Avatar
Thread Starter
Junior Member
 
Joined: Feb 2008
Posts: 38
Likes: 0
From: Bear Creek, NC
Starting Problems... ECU?

Ok my car will start, run for a 1/2 sec at 3k RPMS then it just dies like its life plug was pulled out i checked the ECU or ECM the same thing and has a couple of black burn points at places is this the problem?
Reply
Old Apr 26, 2008 | 04:21 PM
  #2  
91' RX-7 Vert's Avatar
Thread Starter
Junior Member
 
Joined: Feb 2008
Posts: 38
Likes: 0
From: Bear Creek, NC
WTF? no help?
Reply
Old Apr 26, 2008 | 06:49 PM
  #3  
RotaryBred's Avatar
Lost You in the Rear View
Tenured Member 10 Years
 
Joined: Jul 2007
Posts: 560
Likes: 0
From: Rocky Hill, CT
sounds like a fuel starvation problem to me. could be a number of things. do you have a fuel pressure gauge? have someone start it while u watch the pressure. i bet it drops as soon as the engine starts. obviously low pressure means bad pump or filter. hopefully thats all it is. otherwise.. like i said it could be a number of things
Reply
Old Apr 26, 2008 | 06:49 PM
  #4  
jay85gs's Avatar
4x110 SUCKS!
Tenured Member 05 Years
 
Joined: Nov 2005
Posts: 141
Likes: 0
From: Toccoa, GA
You could find someone that has a compatible ecu and ask them if they can loan it too you. Swap them and see if this helps. Also could be something as simple as a fuel filter clogging or a fuel pump on the fritz..................
Reply
Old Apr 26, 2008 | 07:14 PM
  #5  
91' RX-7 Vert's Avatar
Thread Starter
Junior Member
 
Joined: Feb 2008
Posts: 38
Likes: 0
From: Bear Creek, NC
ok... it is fuel starvation i added fuel to the air filter and it would stay running but as soon as i stop it dies, ok it didnt start doing it till i seen black marks or ECU, but i did notice when i take out the middle plug it would run erratic but would run for about 15sec instead of 5 sec
Reply
Old Apr 26, 2008 | 07:34 PM
  #6  
jay85gs's Avatar
4x110 SUCKS!
Tenured Member 05 Years
 
Joined: Nov 2005
Posts: 141
Likes: 0
From: Toccoa, GA
If I were you, I would not push the issue, do not try and make your car run by adding gas to the air filter(a car fire is not something you want). Leave the car alone until you find another ecu. Swap the ecu and see if the car starts and runs on it's own. If you are still having issues after that then check your injectors. Good luck to you.
Reply
Old Apr 26, 2008 | 07:49 PM
  #7  
91' RX-7 Vert's Avatar
Thread Starter
Junior Member
 
Joined: Feb 2008
Posts: 38
Likes: 0
From: Bear Creek, NC
well seeing as its my only vehicle and it will be close to a week b4 my part gets here, im in dire need, anyone near Siler City, NC with one of these would be nice
Reply
Old Apr 26, 2008 | 08:32 PM
  #8  
91' RX-7 Vert's Avatar
Thread Starter
Junior Member
 
Joined: Feb 2008
Posts: 38
Likes: 0
From: Bear Creek, NC
TTT... any more Help???
Reply
Old Apr 26, 2008 | 08:37 PM
  #9  
Rx-7Doctor's Avatar
Lives on the Forum
Tenured Member 10 Years
iTrader: (13)
 
Joined: Jul 2004
Posts: 10,584
Likes: 12
From: Oregon
You need to perform a fuel pressure/volume test.

First check and see if you can hear the fuel pump. Near the oil filter there is a wire harness with a yellow 2 pin connector. Bridge the connectors with a piece of wire then turn the ignition to the on position (not start). Go to the back of the car and see if you can hear the fuel pump making a whirring noise. Might just open the hatch and lift up the rear carpet where the fuel pump is.

If you cannot hear the pump then check the EGI main fuse.
Reply
Old Apr 28, 2008 | 04:34 PM
  #10  
91' RX-7 Vert's Avatar
Thread Starter
Junior Member
 
Joined: Feb 2008
Posts: 38
Likes: 0
From: Bear Creek, NC
ok... does anyone have a pic of this thingy my RX7 manual isnt helping me out too much...
Reply
Old Apr 28, 2008 | 05:23 PM
  #11  
91' RX-7 Vert's Avatar
Thread Starter
Junior Member
 
Joined: Feb 2008
Posts: 38
Likes: 0
From: Bear Creek, NC
bumpy bump
Reply
Old Apr 30, 2008 | 03:35 PM
  #12  
91' RX-7 Vert's Avatar
Thread Starter
Junior Member
 
Joined: Feb 2008
Posts: 38
Likes: 0
From: Bear Creek, NC
TTT... I need some helps
Reply
Old May 2, 2008 | 04:53 PM
  #13  
91' RX-7 Vert's Avatar
Thread Starter
Junior Member
 
Joined: Feb 2008
Posts: 38
Likes: 0
From: Bear Creek, NC
Dude I dont see the 2 pin connector
Reply
Old May 2, 2008 | 04:54 PM
  #14  
91' RX-7 Vert's Avatar
Thread Starter
Junior Member
 
Joined: Feb 2008
Posts: 38
Likes: 0
From: Bear Creek, NC
Bump bump... Keep this open people
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
Jul 1, 2023 04:40 PM
Skeese
Adaptronic Engine Mgmt - AUS
65
Mar 28, 2017 03:30 PM
stickmantijuana
Microtech
30
Apr 23, 2016 06:37 PM
1993fd3sracer1
3rd Generation Specific (1993-2002)
29
Oct 13, 2015 01:57 PM
1993fd3sracer1
1st Generation Specific (1979-1985)
20
Sep 7, 2015 11:50 AM


Thread Tools
Search this Thread

All times are GMT -5. The time now is 10:23 PM.