spark plug wire resistance
#1
Junior Member
Thread Starter
Join Date: Dec 2005
Location: Poway, CA
Posts: 11
Likes: 0
Received 0 Likes
on
0 Posts
spark plug wire resistance
I have a 88 NA rx7 and I need help figuring out which spark plug goes to where. I know that T1 and L1 are the front and T2 L2 are the rear BUT which resistance wires do I use? I have 2 that have 5.56 Kohms and 2 that are about 6.6 Kohms. Do I put the 5.56 on leading or trailing?
I've tried looking in my Hynes service manual. Chapter 5 is engine electrical but it refers me to chapter 1 then refers me back to chapter 5 and can't find anything about what the resistance should be.
I've tried looking in my Hynes service manual. Chapter 5 is engine electrical but it refers me to chapter 1 then refers me back to chapter 5 and can't find anything about what the resistance should be.
Last edited by Komi; 11-01-06 at 06:44 PM.
#2
Lives on the Forum
It doesn't really matter.
The resistances are close enough that it's not going to be that big of a deal.
If they are stock, one has a white mark or tape on it.
That one goes where the leading coil tower with the white mark.
-Ted
The resistances are close enough that it's not going to be that big of a deal.
If they are stock, one has a white mark or tape on it.
That one goes where the leading coil tower with the white mark.
-Ted
Thread
Thread Starter
Forum
Replies
Last Post