General Rotary Tech Support Use this forum for tech questions not specific to a certain model year
Sponsored by:
Sponsored by: CARiD

slow crank; no turn over

Thread Tools
 
Search this Thread
 
Old May 16, 2009 | 08:45 PM
  #1  
bon3's Avatar
Thread Starter
Junior Member
 
Joined: Mar 2008
Posts: 30
Likes: 0
From: Phila. PA
slow crank; no turn over

Hey guys,

My 86 rx7 GXL is not turning over when I turn the key. It slowly cranks as if it wants to turn over but it won't. I have recently replace my alternator, batter and new plugs. Anyone have any ideas? My thoughts were it could be an o2 sensor, fuel fiter or fuel pump. Although from reading on some of the past archives, many mention it may be the starter. So at this point I am unsure of myself what the issue could be.
Reply
Old May 16, 2009 | 09:26 PM
  #2  
bon3's Avatar
Thread Starter
Junior Member
 
Joined: Mar 2008
Posts: 30
Likes: 0
From: Phila. PA
http://www.youtube.com/watch?v=tTAet9vZA9Y

Here is a vid of me starting it.
Reply
Old May 17, 2009 | 03:49 AM
  #3  
AzEKnightz's Avatar
Rotary Freak
Tenured Member 15 Years
iTrader: (24)
 
Joined: Apr 2005
Posts: 2,488
Likes: 8
From: California, SF
why dont you trying giving direct battery voltage to the starter see if it is cranking slowly? If so, your starting is going out. If not, there are too much resistance within the starting circuit.

-AzEKnightz
Reply
Old May 17, 2009 | 09:21 AM
  #4  
boostinfc3s's Avatar
Senior Member
Tenured Member 05 Years
 
Joined: May 2008
Posts: 344
Likes: 2
From: Alameda
good compression? check if you're getting spark from your spark plug wires, other than that check the starter if you've already changed the alternator..
Reply
Old May 19, 2009 | 07:54 PM
  #5  
bon3's Avatar
Thread Starter
Junior Member
 
Joined: Mar 2008
Posts: 30
Likes: 0
From: Phila. PA
Ok. thank you guys for your suggestions but I figured it out. Happens that the car was flooded. I used a technique I read from the forum to get it to run by holding down the clutch & gas pedal then turning the ignition half way to let some fuel run thru the fuel pump then starting it. I tried 4-5 times before I could get it running. A lot of smoke blew out the back.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
Sep 16, 2018 07:16 PM
sherff
Adaptronic Engine Mgmt - AUS
5
Sep 12, 2015 12:22 PM
Monsterbox
Adaptronic Engine Mgmt - AUS
5
Sep 11, 2015 03:29 PM
meetRoX7e
General Rotary Tech Support
4
Sep 11, 2015 11:09 AM




All times are GMT -5. The time now is 03:45 PM.