Signal missing from the Crank Angle Sensor
#1
Junior Member
Thread Starter
Join Date: Apr 2015
Location: Miami
Posts: 14
Likes: 0
Received 0 Likes
on
0 Posts
Signal missing from the Crank Angle Sensor
I have the Microtech computer and module for my large street port 13b engine. This is what is going on right know.
We are not getting pick up signal from the crank angle sensor
Tha C.A.S harness its not spliced or cut
The crank angle sensor both check out good with the resistance specs and also the harness has a resistance of 14.2 ohms on both pick ups and the ground
Any opinion or recomendations are welcome and thanks in advanced.
We are not getting pick up signal from the crank angle sensor
Tha C.A.S harness its not spliced or cut
The crank angle sensor both check out good with the resistance specs and also the harness has a resistance of 14.2 ohms on both pick ups and the ground
Any opinion or recomendations are welcome and thanks in advanced.
#2
Retired Moderator, RIP
iTrader: (142)
Join Date: Sep 2005
Location: Smiths Falls.(near Ottawa!.Mapquest IT!)
Posts: 25,581
Likes: 0
Received 131 Likes
on
114 Posts
I'm not a Tech guru but did you set up the ECU for Cas?
I know when I had my Haltech it needed to be set for my FFE Trigger with a certain tooth count etc...so maybe you need to set the Ecu for Stock CAS???..
I know when I had my Haltech it needed to be set for my FFE Trigger with a certain tooth count etc...so maybe you need to set the Ecu for Stock CAS???..
Thread
Thread Starter
Forum
Replies
Last Post