Signal missing from the Crank Angle Sensor
 

I have the Microtech computer and module for my large street port 13b engine. This is what is going on right know.

We are not getting pick up signal from the crank angle sensor

Tha C.A.S harness its not spliced or cut

The crank angle sensor both check out good with the resistance specs and also the harness has a resistance of 14.2 ohms on both pick ups and the ground

Any opinion or recomendations are welcome and thanks in advanced.

I'm not a Tech guru but did you set up the ECU for Cas?
I know when I had my Haltech it needed to be set for my FFE Trigger with a certain tooth count etc...so maybe you need to set the Ecu for Stock CAS???..