rx7 gen3 engine
#1
Junior Member
Thread Starter
Join Date: May 2007
Location: england
Posts: 8
Likes: 0
Received 0 Likes
on
0 Posts
rx7 gen3 engine
hello to all
Here is my question,i have a rx7 gen 3,which has been standing in the garage for 3 years, without being started or turned over,(due to health problems).
now the big question is what do i have to do to get her running again,is there any specific procedure i have to follow that wont do the engine damage,i know the oil will have to be changed,filters,and new fuel.
i know the trick for reconnecting the battery,resetting the ecu.but is there any thing you would recommend or know that must be done before i crank it over.
any info will be greatfully accepted.
thank you all
broon
Here is my question,i have a rx7 gen 3,which has been standing in the garage for 3 years, without being started or turned over,(due to health problems).
now the big question is what do i have to do to get her running again,is there any specific procedure i have to follow that wont do the engine damage,i know the oil will have to be changed,filters,and new fuel.
i know the trick for reconnecting the battery,resetting the ecu.but is there any thing you would recommend or know that must be done before i crank it over.
any info will be greatfully accepted.
thank you all
broon
#2
"Elusive, not deceptive!”
Broon,
I think I would remove the leading plugs and squirt some oil in the housing, something like Marvel Mystery Oil. Then rotate the front pulley bolt with a ratchet. That way you can feel for a lock or any excess drag.
Does England have Techron fuel system cleaner? Drain the fuel tank and add a pint to 5 gal. of fresh fuel. Get that flowing in the fuel system by energizing the electric pump. No need to start it yet, let it soak for a few days.
Then crank it over with the leading sparkplugs out but connected to check for spark while cranking.
If everything looks OK then try a start-up.
Good Luck,
Barry
I think I would remove the leading plugs and squirt some oil in the housing, something like Marvel Mystery Oil. Then rotate the front pulley bolt with a ratchet. That way you can feel for a lock or any excess drag.
Does England have Techron fuel system cleaner? Drain the fuel tank and add a pint to 5 gal. of fresh fuel. Get that flowing in the fuel system by energizing the electric pump. No need to start it yet, let it soak for a few days.
Then crank it over with the leading sparkplugs out but connected to check for spark while cranking.
If everything looks OK then try a start-up.
Good Luck,
Barry
Thread
Thread Starter
Forum
Replies
Last Post
ncds_fc
New Member RX-7 Technical
1
08-15-15 10:06 AM
KAL797
Test Area 51
0
08-11-15 03:47 PM