I don't own a rx-7, but I'm hoping to soon. The one im interested in though, may have bad seals. And I was hoping how much it would cost to replace them as far as the labor and everything. Also any other general information about the motor would be very helpful. thank you.

 

I could cost anywhere from $1000 to a lot more depending on what else needs replacing. There are a lot of parts that get worn over time and they might need replacing. Also, if a seal 'broke', it can also damage a lot of things and not limited to the turbo(s).

Also, that's just the engine internals. There will be a lot of other work around the engine to take care of depending on the age of the car (which you could end up spending a few thousand getting it back on the road).

 

how much for replace the apex seal only?

 

Same thing as above. You'll never know what needs to be replaced until the engine is completely apart and everything is inspected/measured for tolerances.

 

thx, i just found on the apex seal start breaking. i do not have much money to spend on the car. what is the reasonalbe labour cost for change it. someone tell me to pay 3k for changing the doing that

 

will u change a 3mm seal?

 

If the apex seals are broken that means that the engine is blown. This requires a complete rebuild.

 

yea if ur gonna buy it dont get it built by some shop, get it done by rotary specalist who kno how to build a good motor. trust me any old rotary shop wont do u have to get it done right.