reinstalling emissions?
05-03-05, 06:28 PM
#1
Full Member
Thread Starter
Join Date: Mar 2005
Location: So. Cal
Posts: 189
Likes: 0
Received 0 Likes
on
0 Posts
reinstalling emissions?
i'm strongly considering getting this 89 TII. these are the mods
mods:
New Amico HP clutch PP and THrowout bearing with new piolet bearing and seal installed. Also resurfaced flywheel.
racing beat 2.5 down pipe
3" back to a apexi n1 ( purple) has a dynomax race muffler as a premuffler single exit on drivers side
exhaust has heat wrap... yes all of it
walbro 255 pump
greddy rebic 3 with greddy elbow and 720cc injector
Brand new S5 Turbo from Mazda with Ported waist gate.
hks fcd
perma cool e fan
magnacore plug wires ngk plugs
removed acv, air pump and all emissions
2 3/4 tid with cone filter
the thing is, i live in Cali. what i need to know is, what do i need to do to pass the emissions test? i'm thinking if i install back all the emissions, it should pass. so how hard/long is it to reinstall all emissions.
mods:
New Amico HP clutch PP and THrowout bearing with new piolet bearing and seal installed. Also resurfaced flywheel.
racing beat 2.5 down pipe
3" back to a apexi n1 ( purple) has a dynomax race muffler as a premuffler single exit on drivers side
exhaust has heat wrap... yes all of it
walbro 255 pump
greddy rebic 3 with greddy elbow and 720cc injector
Brand new S5 Turbo from Mazda with Ported waist gate.
hks fcd
perma cool e fan
magnacore plug wires ngk plugs
removed acv, air pump and all emissions
2 3/4 tid with cone filter
the thing is, i live in Cali. what i need to know is, what do i need to do to pass the emissions test? i'm thinking if i install back all the emissions, it should pass. so how hard/long is it to reinstall all emissions.
Thread
Thread Starter
Forum
Replies
Last Post
ls1swap
3rd Generation Specific (1993-2002)
12
10-01-15 07:58 PM