newbee ? please forgive me
#1
Junior Member
Thread Starter
Join Date: Jun 2003
Location: Bend OR
Posts: 23
Likes: 0
Received 0 Likes
on
0 Posts
newbee ? please forgive me
I have an 87 non-turbo. I would like to change the gauges(speedo, temp, fuel, etc.) I had everthing apart and was at the unit w/ the cluster but could get the cluster completely out. One group of wires was that i could not get to was stopping the works. I couldn't find it's begining or end and was alittle scared to start ripping out more of the dash.
So what i am humbly asking is either a step by step instruction on changing the gauges or the name of a company here in Bend or Redmond OR that can do the job for a reasonable price.
thank you for your time
ps if this has been posted please piont me in the right direction. I could not find it
So what i am humbly asking is either a step by step instruction on changing the gauges or the name of a company here in Bend or Redmond OR that can do the job for a reasonable price.
thank you for your time
ps if this has been posted please piont me in the right direction. I could not find it
#2
there is only 2 round plugs that go to the cluster, push the clip in the middle and pull the plug out then just take out the 4 screws in the front corners of the cluster.
Thread
Thread Starter
Forum
Replies
Last Post
turbo-minivan
General Rotary Tech Support
69
02-04-16 12:29 AM
zuesskroph
2nd Generation Specific (1986-1992)
0
08-13-15 06:05 PM