My Rx wont go over 0.5 bar boost...
#1
Junior Member
Thread Starter
Join Date: May 2008
Location: Denmark
Posts: 9
Likes: 0
Received 0 Likes
on
0 Posts
My Rx wont go over 0.5 bar boost...
Just godt my RX started up today.. i was having trouble starting it (it has been standing still for severel months) I pull the plugs out and disconnected the fuel relay and ingnition aswell. then cranked the engine lots and lots of fuel was in the engine.
Back in with the plugs and I finally got i fired up (LOTS of smoke) an let it run for a while.. I carefully took it for a drive and after driving some time i wanted to give it a real spin.. But this is where my problem started.. When it boost's approx 0.5 bar the engine completely stalls.. then a second or to later it bangs out of the exhaust.. it's like it cut's the ignition after 0.5 bar..
The engine I almost stock apart from the Pan speed ECU and some Hardpipes + IC.
Does anyone know what could be wrong?
I didnt do it when i last drove it..
-Lars
Back in with the plugs and I finally got i fired up (LOTS of smoke) an let it run for a while.. I carefully took it for a drive and after driving some time i wanted to give it a real spin.. But this is where my problem started.. When it boost's approx 0.5 bar the engine completely stalls.. then a second or to later it bangs out of the exhaust.. it's like it cut's the ignition after 0.5 bar..
The engine I almost stock apart from the Pan speed ECU and some Hardpipes + IC.
Does anyone know what could be wrong?
I didnt do it when i last drove it..
-Lars
Thread
Thread Starter
Forum
Replies
Last Post
eplusz
General Rotary Tech Support
15
10-07-15 04:04 PM