General Rotary Tech Support Use this forum for tech questions not specific to a certain model year
Sponsored by:
Sponsored by: CARiD

Minimum wiring for turbo 2

Thread Tools
 
Search this Thread
 
Old May 16, 2018 | 09:51 AM
  #1  
Darkstrobe's Avatar
Thread Starter
Junior Member
 
Joined: Jan 2016
Posts: 11
Likes: 0
From: Michigan
Minimum wiring for turbo 2

Hello all
Im on the last few steps of my t2 conversion, (s5t2 in s4na) and I need some final advice for wiring. I have a s4t2 harness and the jdm s5 for connectors if needed. I will go stand-alone in the future but I want to get her on the road for the summer. I want to know the minimum to get the factory ecu to run the engine. I’m guessing angle sensor, spark, oil sensor, coolant temp sensor, fuel injectors, knock sensor, tps, o2, maf and boost. If anyone can confirm or correct this it’d be much appreciated. Ecu is an s4t2 as well FYI
Reply
Old May 19, 2018 | 09:50 AM
  #2  
j9fd3s's Avatar
Moderator
Community Builder
Liked
Loved
Community Favorite
iTrader: (3)
 
Joined: Mar 2001
Posts: 31,835
Likes: 3,232
From: https://www2.mazda.com/en/100th/
http://foxed.ca/rx7manual/manuals/19...TEMS_TURBO.pdf

starting on page 4B-31 it lists the ECU pinouts, and in my experience you need all of the inputs. outputs are up to you, but it runs better the more you have. note that a lot of these are automatically hooked up, this is a lot easier than it looks
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
85rotarypower
1st Generation Specific (1979-1985)
10
Aug 19, 2007 11:01 PM
struhall
2nd Generation Specific (1986-1992)
2
Aug 4, 2007 12:45 PM
FPrep2ndGenRX7
2nd Generation Specific (1986-1992)
12
Jan 23, 2006 08:52 PM
Chimeron
2nd Generation Specific (1986-1992)
6
Jan 3, 2004 02:19 PM
jeff48
Power FC Forum
1
Aug 8, 2002 12:31 PM




All times are GMT -5. The time now is 12:34 PM.