ignitor module replacement on 1st gen
#1
Full Member
Thread Starter
ignitor module replacement on 1st gen
my race car is suffering a power loss from either fuel or ignition issues and I think its the ignitor modules on the side of the distributor. I have heard you can replace the stock ignitiom modules with delco units, any one know how?
#2
Moderator
iTrader: (3)
you have a few options when it comes to the electronic distributor with these engines. check in the Gen I section of the forum. i think they are all in the Archives by now, but i may be mistaken.
of the top of my head, i remember Jeff20B's DLIDFIS, which uses the stock J109 ignitors. however, there are also writeups on systems using the Gen II coil/ignitors and also GM HEI ignitors. i can't remember the authors of those threads, but they are there. a couple of quick searches should bring you all you need to know.
of the top of my head, i remember Jeff20B's DLIDFIS, which uses the stock J109 ignitors. however, there are also writeups on systems using the Gen II coil/ignitors and also GM HEI ignitors. i can't remember the authors of those threads, but they are there. a couple of quick searches should bring you all you need to know.
Thread
Thread Starter
Forum
Replies
Last Post
Boriquaguerrero
2nd Generation Specific (1986-1992)
20
04-22-19 01:15 PM
GKW
1st Generation Specific (1979-1985)
10
09-02-15 10:18 AM
craaaazzy
Comments and Suggestions Archive
3
08-21-15 02:00 PM