Identify these new plates

 

One more question i have a 12a eccentric shaft that got a bit of surface rust i removed most of the rust but there is this small amount of pitting on the area where the rotor bearing goes I will try to put a pic up some time soon but i was wondering if i use 1200 wet aand dry and them some metal polish will i be able to use it ?

 

the rust is similar to this there is a bit of pitting over one of the lobes can this be reused ?

 

Any one??

 

if you are able to remove the spots without doing any damage on the shaft prob,
anyqays you should meassure it

 

j9fd3s needs to see this. I think he used a set of X castings in peepers.

 

Oh ok any idea on the shaft after cleaning it has a slight amount of pitting dont want to rebuild and have problems