General Rotary Tech Support Use this forum for tech questions not specific to a certain model year
Sponsored by:
Sponsored by: CARiD

GSL-SE Ignition Problem ???

Thread Tools
 
Search this Thread
 
Old Mar 30, 2013 | 07:00 PM
  #1  
andernamen's Avatar
Thread Starter
1st Gens are the Best
Tenured Member 05 Years
iTrader: (2)
 
Joined: Apr 2012
Posts: 560
Likes: 0
From: Virginia Beach
GSL-SE Ignition Problem ???

Maybe someone has seen this before. The car will start and run, but after a while, it lags when accelerating to the point of stalling out. Shut off the car for a couple minutes, then it will be fine. I noticed when it does this, the oil pressure gauge reads zero. Could it be trailing coil? Maybe bad igniter? Maybe even a bad fuel pump?

Any thoughts or suggestions appreciated.
Reply
Old Mar 30, 2013 | 07:30 PM
  #2  
diabolical1's Avatar
Moderator
Tenured Member: 20 Years
Liked
Loved
Community Favorite
iTrader: (3)
 
Joined: Feb 2002
Posts: 10,998
Likes: 349
From: FL
start with the fuel filter.
Reply
Old Mar 30, 2013 | 08:41 PM
  #3  
andernamen's Avatar
Thread Starter
1st Gens are the Best
Tenured Member 05 Years
iTrader: (2)
 
Joined: Apr 2012
Posts: 560
Likes: 0
From: Virginia Beach
Its new. Tank was dropped and flushed, screens cleaned, lines cleared.
Reply
Old Mar 31, 2013 | 08:08 AM
  #4  
diabolical1's Avatar
Moderator
Tenured Member: 20 Years
Liked
Loved
Community Favorite
iTrader: (3)
 
Joined: Feb 2002
Posts: 10,998
Likes: 349
From: FL
well, was it behaving this way before you had the tank cleaned?

if you're convinced that the filter (regardless if it's new) is not the issue, then move on to the pump.
Reply
Old Mar 31, 2013 | 11:56 AM
  #5  
andernamen's Avatar
Thread Starter
1st Gens are the Best
Tenured Member 05 Years
iTrader: (2)
 
Joined: Apr 2012
Posts: 560
Likes: 0
From: Virginia Beach
The car sat for five years with a dead engine, but everything was working fine when the engine blew. Different engine now. Yes, will do volume and pressure test next

Last edited by andernamen; Mar 31, 2013 at 12:00 PM.
Reply
Old Apr 1, 2013 | 07:32 PM
  #6  
andernamen's Avatar
Thread Starter
1st Gens are the Best
Tenured Member 05 Years
iTrader: (2)
 
Joined: Apr 2012
Posts: 560
Likes: 0
From: Virginia Beach
Pressure around 50 psi, but volume was less than half a quart in 30 seconds. Time for a new pump? What is the best direct replacement for the stock pump?
Reply
Old Apr 2, 2013 | 12:09 AM
  #7  
misterstyx69's Avatar
Retired Moderator, RIP
Tenured Member: 20 Years
iTrader: (142)
 
Joined: Sep 2005
Posts: 25,581
Likes: 136
From: Smiths Falls.(near Ottawa!.Mapquest IT!)
.just for kicks...how is the voltage when this all happens?..
Reply
Old Apr 2, 2013 | 08:47 AM
  #8  
andernamen's Avatar
Thread Starter
1st Gens are the Best
Tenured Member 05 Years
iTrader: (2)
 
Joined: Apr 2012
Posts: 560
Likes: 0
From: Virginia Beach
Voltage is fine, no issues there.
Reply
Old Apr 11, 2013 | 12:00 PM
  #9  
andernamen's Avatar
Thread Starter
1st Gens are the Best
Tenured Member 05 Years
iTrader: (2)
 
Joined: Apr 2012
Posts: 560
Likes: 0
From: Virginia Beach
New Fuel Pump solved the problem, now on to other issues!
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
SakeBomb Garage
Vendor Classifieds
1
Sep 7, 2015 03:44 PM
SakeBomb Garage
SakeBomb Garage
1
Sep 7, 2015 03:32 PM
SakeBomb Garage
SakeBomb Garage
0
Sep 4, 2015 05:20 PM
SakeBomb Garage
Vendor Classifieds
0
Sep 4, 2015 05:19 PM




All times are GMT -5. The time now is 04:27 PM.