Can I pull the motor with the trans???
#1
Hey, where did my $$$ go?
Thread Starter
Join Date: Feb 2001
Location: Bimingham, AL
Posts: 4,413
Likes: 0
Received 0 Likes
on
0 Posts
Can I pull the motor with the trans???
I wanted to know if anyone has pulled the motor out with the trans still attached??? If so how high up does the car need to be? It is a pain in the ***???
The reason I'm asking is I'm pulling the motor and I'm also pulling the trans for a 5th gear syncro change. It would be easier to pull them both at once then seperate them when outside the car.
So what do ya think?
Oh yea, this is for a 3rd Gen
Thanks,
STEPHEN
The reason I'm asking is I'm pulling the motor and I'm also pulling the trans for a 5th gear syncro change. It would be easier to pull them both at once then seperate them when outside the car.
So what do ya think?
Oh yea, this is for a 3rd Gen
Thanks,
STEPHEN
Last edited by SPOautos; 05-05-02 at 04:24 PM.
#3
Senior Member
Join Date: Mar 2001
Location: Chicago, IL
Posts: 567
Likes: 0
Received 0 Likes
on
0 Posts
Re: Can I pull the motor with the trans???
Originally posted by SPOautos
I wanted to know if anyone has pulled the motor out with the trans still attached??? If so how high up does the car need to be? It is a pain in the ***???
The reason I'm asking is I'm pulling the motor and I'm also pulling the trans for a 5th gear syncro change. It would be easier to pull them both at once then seperate them when outside the car.
So what do ya think?
Oh yea, this is for a 3rd Gen
Thanks,
STEPHEN
I wanted to know if anyone has pulled the motor out with the trans still attached??? If so how high up does the car need to be? It is a pain in the ***???
The reason I'm asking is I'm pulling the motor and I'm also pulling the trans for a 5th gear syncro change. It would be easier to pull them both at once then seperate them when outside the car.
So what do ya think?
Oh yea, this is for a 3rd Gen
Thanks,
STEPHEN
steve
#4
1JZ powered
Join Date: Jul 2001
Location: Where there's only two seasons, hot and wet! I love Okinawa
Posts: 4,423
Likes: 0
Received 0 Likes
on
0 Posts
100 times easier pulling the engine with the tranny still attached. Just remember to pull the stupid shifter out. I forgot to do that when I was doing an sr20det swap
#6
Hey, where did my $$$ go?
Thread Starter
Join Date: Feb 2001
Location: Bimingham, AL
Posts: 4,413
Likes: 0
Received 0 Likes
on
0 Posts
HEHE, yea that was my thread also.
Pulling the motor with the tranny was cake. The only thing is i found out its much easier to take the motor mounts off the motor!!! I struggled with getting it out for a good while then unbolted the mounts and it slid out like pecker out a hot *****!!!! lol
I even left the downpipe on!!!
I'm just curious to see how it going back in will be
STEPHEN
Pulling the motor with the tranny was cake. The only thing is i found out its much easier to take the motor mounts off the motor!!! I struggled with getting it out for a good while then unbolted the mounts and it slid out like pecker out a hot *****!!!! lol
I even left the downpipe on!!!
I'm just curious to see how it going back in will be
STEPHEN
Thread
Thread Starter
Forum
Replies
Last Post
NoMorePoison
2nd Generation Specific (1986-1992)
11
08-18-15 11:18 AM