Ats single plate clutch rattle
#1
Junior Member
Thread Starter
Ats single plate clutch rattle
Hi there
ive got a ats single plate clutch from an fc running in my rx4 with a jc cosmo engine in it. Just wondering if anyone has used one and did you get a rattle in 4th gear? Gearbox has been stripped and checked! Engine is fully rebuilt! The clutch plate doesn’t have any dampener springs in it and has a little bit of movement between the clutch plate and hub! Is this normal? I’ve had no luck with contacting ATS as they haven’t responded. Any help would be much appreciated
ive got a ats single plate clutch from an fc running in my rx4 with a jc cosmo engine in it. Just wondering if anyone has used one and did you get a rattle in 4th gear? Gearbox has been stripped and checked! Engine is fully rebuilt! The clutch plate doesn’t have any dampener springs in it and has a little bit of movement between the clutch plate and hub! Is this normal? I’ve had no luck with contacting ATS as they haven’t responded. Any help would be much appreciated
#2
Rotor or no motor
iTrader: (24)
no rattling with mine but it is using a bearing from a nissan that wont snap on the front cover. it only touches there.
on the fc you dont have to reverse the mechanism like in the fd i suppose. your issue might be there
on the fc you dont have to reverse the mechanism like in the fd i suppose. your issue might be there
Thread
Thread Starter
Forum
Replies
Last Post