88 se no start after tb mod and rats nest removal
#1
Senior Member
Thread Starter
88 se no start after tb mod and rats nest removal
car had a pd problem that caused an engine fire but it was put out within 30 sec. it melted 2 omp lines so i pulled the all the intake off and cleaned everything. i removed the rats nest. i also did the tb mod and ported the intake properly only 2 thousanths. reinstalled everything and started it it started out idling at 6k. adjusted the tb and got it down to 2k did not adjust tps. then tryed to move the cas but it seemed stuck. Wiggled the cas around till it would move. now that everything is back together and the cas is adjusted to factory specs it will not start. yes i have searched and checked the fuses and all the connectors everything is hooked up and no blown fuses battery has a strong 12.6 volts its brand new optima yellow top. turns over but not catching oh and it has compression on both 1 and 2
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
streetlegal?
New Member RX-7 Technical
13
03-17-22 02:46 PM
12abridgeport
1st Generation Specific (1979-1985)
2
08-17-15 06:28 PM