3rd gen wont start...
3rd gen wont start...
I have a 94 fd. Yesterday when driving the car, the car was at a loss of power in normal driving.
Now, when trying to start, after serveral attempts, the car will turn on, sputter for a few seconds and then shut off.
At first I thought it was an electrical or power problem, but i checked the fuses and replaced the battery, but still the same problem.
When it does come around to starting, the car will take a little bit of gas if you rev a little, then it will die out right away. Im not sure if this is possibly a hose problem or possibly an apex/coolant seal.
Any ideas?
Now, when trying to start, after serveral attempts, the car will turn on, sputter for a few seconds and then shut off.
At first I thought it was an electrical or power problem, but i checked the fuses and replaced the battery, but still the same problem.
When it does come around to starting, the car will take a little bit of gas if you rev a little, then it will die out right away. Im not sure if this is possibly a hose problem or possibly an apex/coolant seal.
Any ideas?
Joined: Mar 2001
Posts: 31,835
Likes: 3,233
From: https://www2.mazda.com/en/100th/
step one is to see if the map sensor is plugged it.
its on the firewall close to the oil filter, little box that says n3a1-18-211 on it, make sure the vacuum line is plugged in.
step two, is the check for codes in the ecu
step 3 would be a compression test
mike
its on the firewall close to the oil filter, little box that says n3a1-18-211 on it, make sure the vacuum line is plugged in.
step two, is the check for codes in the ecu
step 3 would be a compression test
mike
Thread
Thread Starter
Forum
Replies
Last Post
demetlaw
3rd Generation Specific (1993-2002)
6
Oct 2, 2015 06:22 PM








