RX7Club.com - Mazda RX7 Forum
And here's the twisted beam pattern - it should be level & horizontal
And here's the twisted beam pattern - it should be level & horizontal
0 2022/11/23 08:12:19
Setting up to test beam alignment. I'm using the unmodified H4 washer as-is here, housing is sitting level on a surface as it would be when installed in the FD, and projecting against opposite wall in my basement.
Setting up to test beam alignment. I'm using the unmodified H4 washer as-is here, housing is sitting level on a surface as it would be when installed in the FD, and projecting against opposite wall in my basement.
0 2022/11/23 08:11:56
Length of projector from stem base to top of lens is just under 100mm. Easy fit within the Spyder housings
Length of projector from stem base to top of lens is just under 100mm. Easy fit within the Spyder housings
0 2022/11/23 07:51:06
Another unpacking picture, showing all the contents.
Another unpacking picture, showing all the contents.
0 2022/11/23 07:51:02
Unpacking - they were packed well and arrived without any damage.
Unpacking - they were packed well and arrived without any damage.
0 2022/11/23 07:50:57
0 2022/11/19 08:29:57
0 2022/11/12 08:00:03
0 2022/11/02 14:03:27
0 2022/11/02 13:57:29
0 2022/10/04 17:05:45
On top we have the "active" or primary E-throttle map - that's the one in play whenever boost is <10.2psi MGP. The yellow circled cells at 50%AP and 4500RPM illustrate what happens when MGP goes > 10.2 psi MGP, and activates the bottom (shown inactive) E-throttle map - notice the cell is commanding 1/2 the throttle it was before - instant soft boost limit!
On top we have the "active" or primary E-throttle map - that's the one in play whenever boost is <10.2psi MGP. The yellow circled cells at 50%AP and 4500RPM illustrate what happens when MGP goes > 10.2 psi MGP, and activates the bottom (shown inactive) E-throttle map - notice the cell is commanding 1/2 the throttle it was before - instant soft boost limit!
0 2022/10/04 16:51:27
0 2022/10/04 16:25:07
Using a needle & meter probe alligator clip to back-probe alternator terminals
Using a needle & meter probe alligator clip to back-probe alternator terminals
0 2022/09/29 11:27:07
0 2022/09/28 16:50:33
0 2022/09/28 13:18:47
0 2022/09/27 07:05:37
0 2022/09/15 07:33:53
0 2022/09/07 14:49:58
0 2022/09/07 14:49:54
0 2022/09/03 03:09:24
0 2022/08/03 18:13:32
0 2022/07/22 04:52:21
I love how solid this thing is now, and that it has 2 pivot points vs. 1 for up & down adjustment - so us taller guys can adjust the mirror so it won't block our vision on tight right-hand corners.
I love how solid this thing is now, and that it has 2 pivot points vs. 1 for up & down adjustment - so us taller guys can adjust the mirror so it won't block our vision on tight right-hand corners.
0 2022/06/17 13:55:43
The ass end is complete now!
The ass end is complete now!
0 2022/06/17 13:47:05
The Mazda eternal flame (aka - toilet bowl) emblem lives again!
The Mazda eternal flame (aka - toilet bowl) emblem lives again!
0 2022/06/17 13:41:54
0 2022/06/09 08:41:44
0 2022/06/09 08:41:38
0 2022/06/03 13:30:15
0 2022/06/03 13:19:23
0 2022/05/27 08:51:08
Here's the installed front left Flex-Z. I also ended up priming & painting (black) that roughly 2 inch patch where the plastic wore down to the metal, re-attached the liner with some new clip fasteners, and added some AL tape to detect future rubbing
Here's the installed front left Flex-Z. I also ended up priming & painting (black) that roughly 2 inch patch where the plastic wore down to the metal, re-attached the liner with some new clip fasteners, and added some AL tape to detect future rubbing
0 2022/05/26 14:25:50
And here's the right rear one installed
And here's the right rear one installed
0 2022/05/26 14:25:42
Yay, they arrived!
Yay, they arrived!
0 2022/05/26 14:12:20
Time to unpack the box...
Time to unpack the box...
0 2022/05/26 14:12:13
And all unpacked & bench inspected
And all unpacked & bench inspected
0 2022/05/26 14:12:08
The AL tape was there to close the seam better, and to act as an indicator of rubbing & sacrificial material. Plastic wore down to the metal though in one spot
The AL tape was there to close the seam better, and to act as an indicator of rubbing & sacrificial material. Plastic wore down to the metal though in one spot
0 2022/05/26 13:53:18
0 2022/05/21 09:37:20
0 2022/05/19 09:54:05
0 2022/04/24 13:19:28
This is actually a picture taken before I restored the mats, but you can see why they were worth restoring!
This is actually a picture taken before I restored the mats, but you can see why they were worth restoring!
0 2022/04/16 06:39:20