RX7Club.com - Mazda RX7 Forum
My FC, at DGRR 2021, and I think Killboy took this one on the same curve he got my FD on last year
My FC, at DGRR 2021, and I think Killboy took this one on the same curve he got my FD on last year
0 2024/01/17 05:06:23
My FD, at DGRR 2023
My FD, at DGRR 2023
0 2024/01/17 05:06:20
0 2024/01/14 09:34:43
Stuff I'm missing is highlighted in yellow in diagram.
Stuff I'm missing is highlighted in yellow in diagram.
0 2024/01/13 16:08:53
The yellow circled screw terminal is what you have to ground - I simply used a suitable ring lug for the screw & 18AWG TXL wire that I grounded to the metal dash support bar with another ring terminal & self-tapping hex screw. To make cluster R&R a little easier with the new ground wire, I added an insulated male/female spade terminal in the middle of the ground wire run to facilitate removal
The yellow circled screw terminal is what you have to ground - I simply used a suitable ring lug for the screw & 18AWG TXL wire that I grounded to the metal dash support bar with another ring terminal & self-tapping hex screw. To make cluster R&R a little easier with the new ground wire, I added an insulated male/female spade terminal in the middle of the ground wire run to facilitate removal
0 2024/01/12 17:07:53
Here's a picture of the old 2" Bi-LED projector. Notice it has more of a "tiny beady eyes" look than the 2.5" Bi-LED projectors (next picture)
Here's a picture of the old 2" Bi-LED projector. Notice it has more of a "tiny beady eyes" look than the 2.5" Bi-LED projectors (next picture)
0 2024/01/12 16:29:33
And here's the finished 2.5" Bi-LED projector
And here's the finished 2.5" Bi-LED projector
0 2024/01/12 16:29:27
Since this is the 2nd time opening up these housings, I removed all the old sealant and replaced it with the pictured Morimoto butyl rubber sealant that I had left over from when I did my HID projector retrofit on my FC
Since this is the 2nd time opening up these housings, I removed all the old sealant and replaced it with the pictured Morimoto butyl rubber sealant that I had left over from when I did my HID projector retrofit on my FC
0 2024/01/12 16:29:21
Finished fogs!
Finished fogs!
0 2024/01/12 16:10:54
Here you can see the corner edge of my IC ducting that interfered with the left fog light housing.
Here you can see the corner edge of my IC ducting that interfered with the left fog light housing.
0 2024/01/12 16:10:01
And here's the left fog installed showing the newly trimmed IC duct - everything fits & works now!
And here's the left fog installed showing the newly trimmed IC duct - everything fits & works now!
0 2024/01/12 16:09:55
Here's the fogs installed on the bumper rebar - here you can figure out why the bumper needs to come off to thread the nuts on those 2 outboard fog bracket studs. This picture also shows the finished fog light sub-harness I had to fab up to connect to the OEM connector on the front (F) harness
Here's the fogs installed on the bumper rebar - here you can figure out why the bumper needs to come off to thread the nuts on those 2 outboard fog bracket studs. This picture also shows the finished fog light sub-harness I had to fab up to connect to the OEM connector on the front (F) harness
0 2024/01/12 16:09:50
0 2024/01/09 11:59:22
0 2024/01/04 13:25:24
0 2024/01/04 13:03:03
This is a block diagram of the speedometer circuit from the FD Service Highlights document
This is a block diagram of the speedometer circuit from the FD Service Highlights document
0 2024/01/04 12:48:04
Chassis is almost done. Need to buy a transmitter/receiver to finish it. Loving the all wheel drive & fully independent suspension. Actually had to assemble the oil filled shock dampers & coil overs myself
Chassis is almost done. Need to buy a transmitter/receiver to finish it. Loving the all wheel drive & fully independent suspension. Actually had to assemble the oil filled shock dampers & coil overs myself
0 2023/12/27 15:04:30
It's a Tamiya 1/10th scale FD radio control drift missile!
It's a Tamiya 1/10th scale FD radio control drift missile!
0 2023/12/27 14:51:59
0 2023/12/15 10:01:25
0 2023/12/15 09:26:15
0 2023/12/08 12:49:53
0 2023/12/06 17:53:07
Driver's seat photo, 11/24/23
Driver's seat photo, 11/24/23
0 2023/11/24 15:29:33
Passenger seat photo, 11/24/23
Passenger seat photo, 11/24/23
0 2023/11/24 15:29:28
0 2023/11/22 15:33:11
0 2023/11/22 11:16:09
0 2023/11/22 09:03:39
0 2023/11/06 06:33:49
0 2023/11/06 06:22:28
0 2023/11/06 06:06:11
0 2023/10/20 13:51:43
0 2023/10/20 13:51:41
0 2023/10/19 12:39:17
0 2023/10/19 12:12:03
And here's the stats for the Senate.
And here's the stats for the Senate.
0 2023/08/16 11:24:16
This one is for the House
This one is for the House
0 2023/08/16 11:24:15
0 2023/07/29 08:41:39
0 2023/07/24 13:08:31
0 2023/07/08 04:42:05
0 2023/07/03 08:57:19