i have noticed a handful of cars have extended the end of the a arm, where can i get a set or how do i make them?

 

any fab shop should be able to do it. it really depends why you're doing it, and if you know how much is really involved with it.
you definitely dont need to do it. i still havent done it.

spindles + tierod ends/spacers are plenty.

 

any pics?

 

post #607 http://www.driftworks.com/forum/drif...-green-31.html

 

Really only needed if you have some insane suspension set-up. You need camber plates and tie rod mods as well.

 

This is what i have done to my car ill post some pics later, the reason i did it was it was a lot cheaper that buying new wheels (as in crazy low offset for angle mods). I run a +35 offset
17x9 rpf1.

 

No need...

 

this is just spindles, and tie rod spacers/washers. not even full angle in any of this.

why do you need more?

http://www.youtube.com/watch?v=tJYeG...layer_embedded

 

I did mine and j. Lowe's a while ago. I got 30mm longer and notched for rad angle.

 

got pictures?