So probably been covered but im on mythe phone, so will 17x10 + 20 fit on the front of a fc and clear with modded knuckles or will I need to space them out? Getting ready for some new wheels and gonna order some hot line knuckles so I need to know.

 

my rpf1's at 17x10 +18 were hitting my coilover already. without a tire. you should go 17x9 with a pretty low offset if your gonna be rocking jtp's knuckles. he would probably be able to tell you the exact size wheel and offset your going to need

 

Extended studs and 10mm slip-ons, or a 15mm bolt-on with shortened stock studs should do the trick. I'm just gonna buy wheels that fit.

 

Yeah but wheels that fit are expensive where as rotas make me cry but they don't look too bad lol.

 

Hahaha go figure. At least you sold those ugly XXRs.

 

I talked to JTP about this a while ago, and it was in another thread. He was running a 17x9.5 with a -16 offset I think? I was planning to get some RPF1s to replace my XXRs. 17x9 +22, then probably slap on a 20 or 25mm spacer once I get knuckles.

 

wasnt there a thread about this a month ago?... not trying to flame as i understand you're on your phone. but i think even jtp commented on his setup and what's recommended.

 

this might help.
http://www.rimtuck.com/thumbnails.ph...clemodel=RX-7&

 

You could run 8.5's with no stretch. Bolt on spacers and fender moddddddzzzzzz r ur best frenz.