Need to clean up a 2nd gen. rear sub-frame, control arms and maybe a few more parts. Will pay (just to be clear).
Anyone that can do this or refer me to a place please let me know.
Or, is renting feasible?
Thanks.
Paul

 

Styx or another mod. Maybe this should have gone in the for sale/wanted section? D'oh!

 

nah..yer good here.!

I should tell the EX about this.
She always rubbed me the wrong way,so with her and a wire brush I think it would be done in a half hour..HAHAHA!

 

Lol styx good idea. Found a place after lots of searching. Body shops didn't do it and most sand or media blasting places only wanted big jobs. Ended up costing $100. Not too bad, considering the result. Bristol plating in Etobicoke. No after pic...will take one tomorrow.

 

contact info for bristol??

 

Bristol plating, 43 advance road, Etobicoke.
Next time I disappear, send a PM

 

Do you still need these done? If so you could drop them off at my shop and I could bring them up to my dad (was GPEngineering in Etobicoke). We still do powder and ceramic coating and sand blasting, just not as GPEngineering anymore.

My shops located in Etobicoke near 27 & Steeles.

 

Got my stuff done, but always like another option for in future. I think your Dad resurfaced my flywheel. Were you messing with an old Rx-3 with a buddy in the back last year? Or maybe two years ago? Lol

 

No Rx3 but I did have a green NSU RO80 parked in the back I was working on.

 

Yes, it was you then. Lol, I wasn't sure I remembered the car right. RX3 was my best guess with my terrible memory. What are we talking about again?