Hey guys, i'm in the midst of doing a full rebuild and a bunch of other crap on my JDM FD and i was wondering about the speed cut at 180kph. I know on the FC's you just had to take a screw out of the back of the gauge bezel because i did that to my last JDM FC, but i'm wondering what you do to the FD's? If there's no quick fix like that i have an HKS Speed Cut Elimintor that i could wire in but i dont know where?

I could really care less if the car goes over 180 or not on the streets. i just need it to go over for when i put it on the dyno to tune.

Any info would help.

Thanks,

Chad

 

You should be fine I had my CAN FD up to 240kph when it was completly stock with no cut out I dont even think the FD has a speed limiter.

 

In Japan all cars are limited to 180km/h, hense the speedos only going that high.

 

Bingo.

 

https://www.rx7club.com/3rd-generation-specific-1993-2002-16/speed-limiter-180km-h-627096/