Any Toronto rx7 owners
#2
Hey...Cut it out!
iTrader: (4)
Our resident demigod Aaron Cake is is London, Ontario. I'm just across Lake Erie, a few miles south of Cleveland. When I can afford to get my 20B rebuilt, I'll probably be going to Defined Autoworks (Pataskala, OH). Out of curiosity, what kind of work are you seeking to have done and what are the details for the car in question?
#3
Junior Member
Thread Starter
Just bought a spirit r from Japan it’s on route . Has single turbo conversion a lot of hks work will need to get the fcon vpro programmed to fuel and set up in Canada and dyno d
Trending Topics
#8
What is this "the meet" you speak of? I'm relatively new, have an old 'Rex, and want to go to a rotary meet. Caveat: I work overseas and only will be back for the first three weeks of August. I'm seaching the forum now for get together posts.
#10
#11
Senior Member
not in ontario but Derwin performance outside of Montreal is a very clean shop with a wealth of knowledge.
Derwin Performance Rotary Engine Specialists in Canada
<6 hr drive from Toronto.....
Derwin Performance Rotary Engine Specialists in Canada
<6 hr drive from Toronto.....
#12
Senior Member
iTrader: (4)
Chips Motorsports is on the North side of Detroit, not far after you cross the boarder.
https://chipsmotorsports.com/
My Streetport 12A is with him now for a rebuild.
Not sure if there is a better place in North America you could take an engine!
https://chipsmotorsports.com/
My Streetport 12A is with him now for a rebuild.
Not sure if there is a better place in North America you could take an engine!
Last edited by tommyeflight89; 06-22-18 at 04:26 AM.