i modified an old school nikki bell crank to fit the bettee for quick throtle response

 

Not sure what the Nikki Bell crank is...but I do have my old carb from my 12A...I'll check it out and might fab one my own up tonight....thanks Siraniko

 

Well....decided I just better get something good...got a bottom mount Weber/Redline linkage kit...new horns and new filters to go snug just around the lip of the horns...pics next week when it gets here...then off to tune....

 

Not sure how to put youtube on here...but link is below to car running after the smoke show finally stopped.

 

Dang....struggling with this Redline throttle linkage kit. I got it all in....and had to tweak the assembly so it cleared the block and bolt on trans.....now the cable itself is not very forgiving...maybe a reroute of cable is needed. Seems like the pitch angle of the fire wall grommet is off and keeps cable from sliding smoothly. Ohhhhh these cars....might cut oem cable to use the oem firewall grommet and run this cable through it for correct pitch.

Also, got a one off **** from Landon....Racing Beat design we came up....sweet!!! Pic coming...

 

I just used the stock throttle cable and hacked up the existing FC bracket that would normally bolt to the intake manifold. No cutting of cable nessecary, routes pretty similar to stock.

I like the setup alot! I've been tempted to go to a 50 since my mikuni is too small but I like having a choke.

 

Sorry for delay.....got car complete....braking in clutch still...but tough to put miles on it with this weather.

 

Got left over parts from completing both....PM for details and pics...need to dump this stuff...

motor mounts
wideband
gauges
datalogit
fpr
din panel
etc