Build Threads The place for complete build threads of 1st Gen RX-7s.

Holley Problem

Thread Tools
 
Search this Thread
 
Old Jul 1, 2014 | 11:30 PM
  #1  
FINFAN's Avatar
Thread Starter
FinFan
 
Joined: Apr 2014
Posts: 13
Likes: 0
From: Macungie, PA
PA Holley Problem

I have an 82' with a fresh 13B motor, Racing Beat intake and Racing Beat Holley carb to match. I was having a lot of hesitation and back firing when trying to drive the car. I took it to my friend's garage, replaced the primary coil, advanced the timing, and tuned the carb a little bit. Runs like a champ now, however, it is a bear to start, it actually takes two people to start the car, one to hit the starter, and another to hold the throttle linkage wide open, after about 30-60 seconds of cranking, it finally catches and fires up with a bunch of blue smoke.

Before this, it would start up without even the choke being on, after about 5 seconds cranking the starter. Where should I go from here? It's been a long time since I have done any work on a carb, so I'm kind of at a loss here where I need to start touble shooting.
Reply
Old Jul 1, 2014 | 11:40 PM
  #2  
Siraniko's Avatar
RX for fun
Tenured Member 15 Years
iTrader: (13)
 
Joined: Aug 2001
Posts: 15,926
Likes: 25
From: Socal
Reinstall the dizzy and make sure the motor is at TDC
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
Sep 16, 2018 07:16 PM
heywier427
Naturally Aspirated Performance Forum
2
Sep 11, 2015 04:49 PM




All times are GMT -5. The time now is 12:07 PM.