I picked up this car few weeks back with a popped motor. I was on the fence on what to do with it. Brad at R.I.P is doing the build for me, all new motor and new tranny along with a new Billet Precision.





When we loaded it up in St. Louis had been setting for a good bit.





Got it back to a buddys Shop until i was able to get it to Brads.





And as it sits now. Hope to have it up and running very soon :headbang: Want to make 600+whp range. Should be a fun car!

And my Wepon of Choice.



When i picked up the car: It had

Rx7store Half Bridge motor.
-Dual fuel pump setup. "Ultimate fuel setup" from Rx7store with fuel rail and FPR
-Greddy 3 row intercooler
-Greddy Type R BOV
-Aquamist stage 2(I believe) for alky injection.
-850 primaries and 1620 secondaries
-Spec Stage 4 clutch
-Feed spec 2 front end
-Feed carbon fiber side skirts
-Enkei RPF-1 17" wheels with bridgestone DOT street/drag tires
-Boost, Fuel, Wideband, and radar detector for gauges.
-Power FC
-EBC brake pads with drilled and slotted rotors
-Tokico Illumina 5 way

 

I saw your FD when I dropped my motor off for Brad to build. I'll finally get him the funds to start next week. Then I'll be bring the chassis over for him to install and convert to manual. Looks good.

 

lucky you.... lookin for a builder right now. looks good after clean up.

 

Any update?

 

http://www.youtube.com/watch?v=vYKTH...e_gdata_player

Brad at Rotary Inspired Performance did a amazing job in a very short time! He had to re do alot of prior shops works, so it set the dead line back a bit. But i am happy how quick he got a 100% fresh build out.

 

sounds great! when will you dyno it?

 

Very nice. I can't wait to drop mine off for the motor install next week.

 

sounds awsome

 

Thanks for the kind words Jrod. Finish that break in and lets have some fun.

 

http://www.youtube.com/watch?v=BvQXE...layer_embedded

http://www.youtube.com/watch?v=ouzCn...layer_embedded

Few more clips of it.