I've finished installing an AEM system. Seems to be working correctly. I teed into the vac line I have running to a boost gauge and took the boost signal from there. I think this is alright but I'm not sure.

I installed the boost gauge at the same time as I was installing the AEM system. It's a VDO gauge and I'm trying to determine if having it connected to the same boost pressure line as the injection controller is messing up the boost/vac readings or if it will effect when the pump turns on and off.

As best as I can tell the controller comes on at about 4psi which is close to where I tried to set it to start.

Just trying to knock out a few possibilities as to why the boost is maxing out at 6.

My guess is that I have to redo the rats nest and the the seq system is not working properly but it could also be the gauge but I doubt it.