whats the setup your running from dynatek?

 

ive got the ARC2 module and the DC12-1 Coils

 

You running it directly off the ecu or using an igniter in between the ecu and cdi?

 

would it still be two ARC2 units with four DC12-1 coils used?
thanks

 

Ive taken my signal from the leading wires between the ecu and x4 microtech box

I am only running the ARC2 on the leading spark only - Not trailing.

 

I'm running the dynatek cdi from the microtech with internal ignitors (ltx8) with a dynatek coil for each leading plug with a Bosch HEC715 coil for each trailing plug.

 

heres a update vid of my sound thats coming from my arc2...

anyone whos got the arc2 had these sounds comign from theirs or any ideas what would be causing mine too..

http://s1017.photobucket.com/albums/...nt=arc2new.mp4

 

im still waiting on mine to get in. could i get away useing the stock leading coil for mean time?

thanks again

 

lev checked his one and it ticks but it dosnt affect performance. his car almost tipped 500hp on the weekend.

 

i got my arc2 checked out by dynatek usa - they said it was fine but the replaced it for a car verson .. dont know what that merans..

installed tonight and still the same noise... it must be how it is..

 

do u mean on the leading u don't need the x4 box just on trailing?

I decided to go with dynatek but I did fry my x4 on leading only,
my trailing ignitors r still good,

so if I use the arc2 on leading of the signal beatween the x4 and ecu,
and have the x4 fire my trailing can I still use my toasted x4?

 

is the noise still there?

do u like the setup, any other problems with it?

 

is there a way to get the arc-2 to fire dynatek coils off the microtech lt8s single wire signal that doesnt use the x4 box?
im going to the dyno next week and would like to have it in the car if its posible

 

so any one with some update to the dynatek arc2 running only in the leading?
the box is cheap i would like some feedback so I try it out or not

 

Bump for info

 

i tried to get mine hooked up but my lt8s doesnt use the x4 microtech box and i tried to connect to the oem fc leading coil with no success.. been on the shelf ever sence..