aquamist tuning configuration
#1
Racing Rotary Since 1983
Thread Starter
iTrader: (6)
aquamist tuning configuration
assuming you do not wish to mimic the injector duty cycle and want the spray to start at X psi and then wish to manually set the levels of injectant...
using either the 2C-D-S or the new offering what do you use? a laptop? is there an X and Y grid? if so how many cells? i searched the website and was unable to find the answer and the AQ forum is currently down.
TIA
hc
using either the 2C-D-S or the new offering what do you use? a laptop? is there an X and Y grid? if so how many cells? i searched the website and was unable to find the answer and the AQ forum is currently down.
TIA
hc
#4
Junior Member
iTrader: (1)
If it does allow control through the use of a laptop, then it would be nice.
However, I intend to modulate the output of both the HSF-5 systems that were recently purchased via each car's ems.
The excellent quality high speed valve (HSV) that Aquamist employs is ideal for this purpose, and the ems allows full 3d control, just like an injector.
However, I intend to modulate the output of both the HSF-5 systems that were recently purchased via each car's ems.
The excellent quality high speed valve (HSV) that Aquamist employs is ideal for this purpose, and the ems allows full 3d control, just like an injector.
Thread
Thread Starter
Forum
Replies
Last Post
demetlaw
3rd Generation Specific (1993-2002)
6
10-02-15 06:22 PM