i was wondering if the porting in the 5th and 6th port chambers would affect the sleeves sliding in and out. there is mild slack. should i just remove them or is this ok?

 

you can remove them however the car may run a little funney with 6 wide open poarts... I have had othere do the same this and the car was not effected by it where others were..

as for porting the 6 ports I would port the inside of it and not the intake runner...

Dan

 

will the slack hurt anything?

 

I dont think it will hurt.. the worse thing that I can see happening is dirt or carbon can get in between the valve and the iron and make the valve stop moving...

Dan

 

thanks dan.

 

any reason this is in the Vendor/Group Buy section?

 

I personley dont mind if anyone posts in my section of the board to ask a Questions on how something works...

Not only that I have seen a lot of BS in threads like this lateley and I dont know why, and again I dont mind the questions no matter how simple or complex it is to others...

Dan

 

my bad....

 

89rx if you have any more Questions please post here anytime...

Dan

 

Dan,
Has anyone come up with a really good system for actuating the 5th & 6th ports? I have done a total emissions strip along with HKS exhaust on my 88 NA and am researching port actuation possibilities.

 

Not that I know of, outside factory parts....

However I would look at this link as it does give good info plus kevin is a good frend of Atkins..
http://www.rotaryresurrection.com/1s...elec6port.html

Dan

 

Dan, you sir are a man with integrity and character !