AEM Props to AEM
#1
Senior Member
Thread Starter
Join Date: Apr 2005
Location: TX
Posts: 402
Likes: 0
Received 0 Likes
on
0 Posts
Props to AEM
Hi guys,
I recently bought a used AEM EMS for my friends FD, and when the box came, the board was rattling inside the case ( the set screw on the bottom was stripped). I did some further research, and found out that this box is Johnny Englsih old AEM box for the 20B 3rotor.
So I sent the box to the AEM main office in Cali, to look at the set screw issue, and also to check the jumper settings, and test the box to make sure it is good, since we bought it used.
AEM returned the box the next day, free of charge, and the set screw was fixed. They tested it, and everything is fine with it.
I just wanted to give major props to one of the best standalones on the market. I know a lot rx7 people had some issues, partly because of the tps wiring problem, and partly bacause the AEM is so advanced, it should be tuned only by experienced tuners. So the AEM customer service proved to be one of the best again.
I recently bought a used AEM EMS for my friends FD, and when the box came, the board was rattling inside the case ( the set screw on the bottom was stripped). I did some further research, and found out that this box is Johnny Englsih old AEM box for the 20B 3rotor.
So I sent the box to the AEM main office in Cali, to look at the set screw issue, and also to check the jumper settings, and test the box to make sure it is good, since we bought it used.
AEM returned the box the next day, free of charge, and the set screw was fixed. They tested it, and everything is fine with it.
I just wanted to give major props to one of the best standalones on the market. I know a lot rx7 people had some issues, partly because of the tps wiring problem, and partly bacause the AEM is so advanced, it should be tuned only by experienced tuners. So the AEM customer service proved to be one of the best again.
Thread
Thread Starter
Forum
Replies
Last Post
eplusz
General Rotary Tech Support
15
10-07-15 04:04 PM