AEM keep 'follow ecu' active?
#1
keep 'follow ecu' active?
Anybody know if there is a way to keep the 'Follow ECU' function active permanently on the fuel/timing maps? Right now it only stays active until you make a change, then you have to click it again.
I hate to admit it, but I am sometimes guilty of driving and tuning at the same time when I am trying to get cruise areas of the map set just right, and having to reclick that checkbox annoys the crap out of me....
I hate to admit it, but I am sometimes guilty of driving and tuning at the same time when I am trying to get cruise areas of the map set just right, and having to reclick that checkbox annoys the crap out of me....
#4
Have you tried the AEM tuner software? May not be to your taste gui wise if you are used to Pro. But from experiance it does stay following - I'm thinking of getting a small USB keypad to temp mount to the center console so I can +/- fuel without taking my eyes off the road.
#7
I have not had any free time to spend with the car. We took it for a drive yesterday but my wife is used to AEMPro so I did not try to get her using Tuner. I will let you know once I have a few minutes free. Just from looking at my work computer the GUI looks fine.
Trending Topics
#9
Senior Member
iTrader: (1)
Join Date: Jun 2010
Location: Santa Monica
Posts: 475
Likes: 0
Received 0 Likes
on
0 Posts
AEMtuner is not approved or supported for series I ecus. It does work. And it is a lot nicer interface but some of the tables do not translate between the softwares. So just pay attention to what you are looking at.
EB Turbo
EB Turbo
Thread
Thread Starter
Forum
Replies
Last Post
rx8volks
Canadian Forum
0
09-01-15 11:02 PM