AEM Help: Base map needed for 6x1000cc injectors GM 3 bar map gt42
#1
Help: Base map needed for 6x1000cc injectors GM 3 bar map gt42
Hello guys im looking for a base map to start my car:
im running AEM ems ecu
xcessive lim
6x 1000cc injectors
gt4202r turbo
banzai racing 3 bar gm map sensor
Already set the primaries and put the correct gm bar on the wizard.
i really dont want to mes much with the ignition ill apreciate any help.
thanks
im running AEM ems ecu
xcessive lim
6x 1000cc injectors
gt4202r turbo
banzai racing 3 bar gm map sensor
Already set the primaries and put the correct gm bar on the wizard.
i really dont want to mes much with the ignition ill apreciate any help.
thanks
#2
watashi no shichi
iTrader: (4)
you wont need to mess with ignition related parts..
once you've set the injector sizes, use the "calibrate TPS" screens to ensure your tps reads above 0.0v and below 1.0v
from there - you'll need to adjust the cranking map because it'll most likely flood the car.
next you'll need to adjust the fuel map a little bit (i would remove 15% overall for starters).
There is an FD-specific help guide coming but for the moment, hang on and i'll write something better when i get home.
once you've set the injector sizes, use the "calibrate TPS" screens to ensure your tps reads above 0.0v and below 1.0v
from there - you'll need to adjust the cranking map because it'll most likely flood the car.
next you'll need to adjust the fuel map a little bit (i would remove 15% overall for starters).
There is an FD-specific help guide coming but for the moment, hang on and i'll write something better when i get home.
Thread
Thread Starter
Forum
Replies
Last Post
stickmantijuana
Engine Management Forum
11
11-09-15 01:15 PM
befarrer
Microtech
3
08-22-15 05:52 PM