Adaptronic Secondary injector timing in VE
I always thought that it wasn't 98% actual duty, but 98% of the duty limit (85%)?
Not sure if I saw that somewhere or assumed it though.
but Andy proved the same thing out on the Series 1 Renesis 6-port/injector engine using the PnP Modular ecu.
commented on it recently in another thread:
https://www.rx7club.com/new-member-r.../#post12574525
.
Not sure if I saw that somewhere or assumed it though.
but Andy proved the same thing out on the Series 1 Renesis 6-port/injector engine using the PnP Modular ecu.
commented on it recently in another thread:
https://www.rx7club.com/new-member-r.../#post12574525
.
Last edited by TeamRX8; Sep 20, 2023 at 05:53 AM.
Thread Starter
Joined: Feb 2017
Posts: 477
Likes: 46
From: Bay area California
I recently rebuilt a rx8 motor for a friend and had a core motor with two extra primary 290cc injectors. So I put those in. Used the dead times from the rx,8 base map in WARI. Right off the bat car ran with no real adjustment to the map (just reduced the whole map a couple clicks) just to get it started. But as far as I can tell. The secondary yellow RX-8 460cc are being activated. Car hauls *** all the way to red line. So I doubt it's just the primary's. Will tune it more to get it dialed in. Very happy with the results so far.
Thread
Thread Starter
Forum
Replies
Last Post