Hello,

I have recently upgraded to FFE rails and ID 1000 injectors, 850cc primary, 1000cc secondaries. I also installed the FFE Mag Trigger wheel. before this, I had direct fire coils (sake bomb kit) and BRN stage 3 non-sequential running 10psi. The car ran on the DFI setup last year. So, the injectors, new pump and FFE trigger were installed. Pump is working, everything seems alright. I have no signal to the injectors, as they are not firing at all. Any thoughts on what could be the issue? I've attached the map I have on the car currently. It's based off the FFE base map. Thanks.

 

I was able to get help from Adaptronic support. I'll post the resolution once I have confirmed. Adaptronic has a great team and they'd been very helpful! I've had my map checked for config as well. This is a street tune by Elliot at Turblown that was setup for BNR Stage 3 in non-sequential configuration @ 10psi. Also with full exhaust, FFE reluctor trigger, ID 850cc primaries, 1000cc secondaries and the Sakebomb Direct fire ignition kit. Feel free to take a look.

 

maybe the injectors you had were running on high imp or low imp..... I can never keep them straight. do you have resistor in your harness?

 

Are you getting an RPM signal inside the ECU? If the trigger is not configured or wired correctly the injectors are not going to fire.