Adaptronic Innovate DLG-1/LC-2 with Universal Select 440d
#1
Innovate DLG-1/LC-2 with Universal Select 440d
I contacted Adaptronic Support but I'm wondering if anyone here has used a dual wideband with this ECU. The gauge is displaying properly, but I'm not getting AFR values in the ECU or logs. Oddly though, EGT2 and EGT4 are spitting out values and I'm wondering if the ECU is just confused. I played with the settings but didn't find anything that corrected the issue. Anything I should try?
#5
Sorry about those photos, they were related to a private conversation. Just in case anyone ever encounters this thread in a search the solution for using the DLG1/LC2 is as follows...
Don't bother using the serial port to connect it to the 440d. Instead, connect the yellow wire of the LC2 to the white wire, pin 1C, of the 440d. That should give you the correct readings on the calibration tab once you select Innovate from the drop down on the calibrations tab.
Don't bother using the serial port to connect it to the 440d. Instead, connect the yellow wire of the LC2 to the white wire, pin 1C, of the 440d. That should give you the correct readings on the calibration tab once you select Innovate from the drop down on the calibrations tab.
Thread
Thread Starter
Forum
Replies
Last Post
Adaptronic 13b na ignition map select 440d.
Holdfast
Adaptronic Engine Mgmt - AUS
14
05-17-18 09:57 AM
Adaptronic e440d Universal Select S5 Turbo
jreynish
Adaptronic Engine Mgmt - AUS
7
04-15-16 01:13 PM
Adaptronic speed sensor Wiring 440D Select
vetteracer79
Adaptronic Engine Mgmt - AUS
2
10-02-14 05:04 AM
mannykiller
Adaptronic Engine Mgmt - AUS
49
06-18-13 12:45 AM