Innovate DLG-1/LC-2 with Universal Select 440d
I contacted Adaptronic Support but I'm wondering if anyone here has used a dual wideband with this ECU. The gauge is displaying properly, but I'm not getting AFR values in the ECU or logs. Oddly though, EGT2 and EGT4 are spitting out values and I'm wondering if the ECU is just confused. I played with the settings but didn't find anything that corrected the issue. Anything I should try?
|
https://cimg7.ibsrv.net/gimg/www.rx7...b757a0a2e8.jpg
only thing i added to it was the cutoff % on the top right. i put that at a 100. |
Can you click the Asynch Accel Pump button and show me that table?
|
|
Sorry about those photos, they were related to a private conversation. Just in case anyone ever encounters this thread in a search the solution for using the DLG1/LC2 is as follows...
Don't bother using the serial port to connect it to the 440d. Instead, connect the yellow wire of the LC2 to the white wire, pin 1C, of the 440d. That should give you the correct readings on the calibration tab once you select Innovate from the drop down on the calibrations tab. |
All times are GMT -5. The time now is 05:46 PM. |
© 2024 MH Sub I, LLC dba Internet Brands