Hi everyone, ive finally decided to swap out my Power FC with an Adaptronic. I had one quick question about injectors for you all. My current injectors in the car are 750cc Simmens and 1680 Bosch low impedance injectors. In order for me to run these injectors on the Power FC I needed to run resistors (4) to each one of the injectors. When I switch my ECU is it necessary that I remove these resistors? Is it possible / fine if I leave the resistors wired in with the Adaptronic PNP S6 ECU? Also is it possible I run 2 low impedance injectors and 2 high impedance injectors at the same time?

Thanks in advance.

-Andrew

 

You do not, and should not use resistors with the Adaptronic. Yes you can run high impedance and low impedance injectors together. Each bank must run the same impedance however. So primaries must both me the same, and secondaries must both me the same... Make sense?

 

Got it crystal clear. Thank you for the quick answer. Looks like I will be pulling the harness!