Adaptronic Adaptronic PnP, AEM coils in direct fire - T2 not firing
#1
Adaptronic PnP, AEM coils in direct fire - T2 not firing
Hello,
I have a turblown built 13brew, also adaptronic PnP supplied by him. All my trigger wires are hooked up according to the pinout diagram, but T2 is still not receiving a trigger signal, or spark. I have switched out the coil in the hope it was bad, but to no luck. I'm also running factory trigger sensors. Everything has been setup in WARI, (custom, then direct fire 2 rotor). But still no spark.
-JGappa
I have a turblown built 13brew, also adaptronic PnP supplied by him. All my trigger wires are hooked up according to the pinout diagram, but T2 is still not receiving a trigger signal, or spark. I have switched out the coil in the hope it was bad, but to no luck. I'm also running factory trigger sensors. Everything has been setup in WARI, (custom, then direct fire 2 rotor). But still no spark.
-JGappa
#2
Rotary Freak
iTrader: (10)
Adaptronic PnP, AEM coils in direct fire - T2 not firing
The most common issue with direct fire conversions are wiring the coils. However, as a preliminary troubleshooting measure, what does the IGN LEDs do on top of the ECU? You can email Adaptronic Tech Support with your ROM, as well as a video of the LED pattern if you wish to assist in troubleshooting.
#3
The most common issue with direct fire conversions are wiring the coils. However, as a preliminary troubleshooting measure, what does the IGN LEDs do on top of the ECU? You can email Adaptronic Tech Support with your ROM, as well as a video of the LED pattern if you wish to assist in troubleshooting.
Thread
Thread Starter
Forum
Replies
Last Post
SakeBomb Garage
SakeBomb Garage
0
09-04-15 05:20 PM
SakeBomb Garage
Vendor Classifieds
0
09-04-15 05:19 PM