aruba

i hate this f**k pull type clutch thing


does any body have or makes a hydraulic release bearing for our tranny
i would just buy an 2gen pressure plate
THAT RING THAT CLICKS IN THE PRESSURE PLATE KEEPS ******* UP AFTER MANY TIMES OF PULLING THE ENGINE OUT

or any body HHHHHHHHHHEEEEELP

cmartinp28

os giken sells the pull to push kit for like 400 dollars...

why dont you get a TII bell housing, it should bolt up

aruba

So Just Get The Turbo2 Bell Housing And
Get The Turbo 2 Pressure Plate And Fork Etc????

YoshiFD3S

iTrader: (19)

<)-----uses OS Giken twin-plate clutch, pressure-plate, and lightened flywheel.

Besides the scraping sounds that twin-plate clutch makes, it's very fun to drive. Not very fun for stop-and-go traffic, but shifts so well I can't resist.

Short-shifter makes it kinda notchy though. :/

aruba

Would It Still Be Pull Type
????
The Reason For Swithching Is That I Dont Want To Use That Stupid Rounds Clip Again In The Center Of The Pressure Plate

jd to rescue

iTrader: (3)

That "ring" is actually a two-piece assembly. There is a wire ring and a wedge collar. They are to be replaced after each disassembly, i.e., they are not to be reused.

aruba

Dealer Sell That 2 Piece Collar And Ring For $40 Each

Any Other Idea
What Can I Do
Do You Have A Webbsite Were To Buy The Osgiken Kit??????

Thanks Guys
Any One Sells A Hydraulic Release Bearing???

FDNewbie

iTrader: (10)

aruba, PM me if you're looking for an Os Giken push type clutch w/ pull to push conversion kit. I can get it new or used (= a LOT cheaper)

~Ramy

aruba

pm sent