WOOOHOO! hlp ASAP!!!!
#1
Rotary Enthusiast
Thread Starter
WOOOHOO! hlp ASAP!!!!
I think I found my secondary turbo problem! while crawling under my car to blow my turbo's into non sequential, I notice that the little rod thats attatched to the switchy thingy right behind the TCA was popped off! would that cause my good primary, but my secondary to drop from 8to about 4???
Stevo
Stevo
#4
Rotary Enthusiast
Thread Starter
'
Sorry its kind of blurry! but u can see it popped off, now I tried pushing this sucker back on but I Cant seem to get the rod in far enough to put it back on the c-clip... any suggestions?
Sorry its kind of blurry! but u can see it popped off, now I tried pushing this sucker back on but I Cant seem to get the rod in far enough to put it back on the c-clip... any suggestions?
Trending Topics
#8
Meesto Spakaro
Join Date: May 2001
Location: Redondo Beach, CA
Posts: 489
Likes: 0
Received 0 Likes
on
0 Posts
it will be much easier to disconnect the TCA first. Just take out the two bolts, probably dont even need to disconnect the vacuum lines...slip the rod back on, put on a c-clip so it doesnt slip out again... shouldnt take more than 10-15 minutes