Ok guys i have being working on my single turbo conversion for the past few months, and have being working on the harness on and off about the same time. Now I'm about 90% done in the conversion and got the engine harness done and ready to install and i noticed that the white main connector on the harness is missing 3 wires and the mating connector for this connector is only missing 1 wire, i need to see if someone could verify that i didn't removed wires from this connector, and if i did what they were for.

Here is the picture of the white connector on the engine emissions harness.

 

better pic

 

X-14? if it is it goes up behind the glove box

 

That's correct it is the x-14 connector, after spending most of the night i found it in the wiring schematics on the common connector list. For the x-14 I'm only missing one wire, the other 2 are blanks, the one that I'm missing is the BR/Y wire, i have being trying to locate it on the schematics but cant find where does it need to be hook up to.

Any help will be greatly appreciated, as im not that good reading electrical schematics.

Thanks.