where does this wire go? - engine bay
#1
Full Member
Thread Starter
Join Date: Oct 2010
Location: South West of England
Posts: 62
Likes: 0
Received 0 Likes
on
0 Posts
where does this wire go? - engine bay
Hey guys i recently noticed a wire broken away in my engine bay. Its black with a red stripe. The only thing that doesnt seem to be working is the oil pressure gauge. Does it go to the oil pressure sensor? If not where does it go?
Please see picture below. Ive put it in connector block for now.
THANKS
Please see picture below. Ive put it in connector block for now.
THANKS
#3
Full Member
Thread Starter
Join Date: Oct 2010
Location: South West of England
Posts: 62
Likes: 0
Received 0 Likes
on
0 Posts
no its not attacted a wire has broken off.
But the one in the photo above isnt long enough/wont reach the OPS.
I didnt want to connect the two put until i was sure
But the one in the photo above isnt long enough/wont reach the OPS.
I didnt want to connect the two put until i was sure
#4
Rotary Enthusiast
what color is the wire that was broken off ??? is there a piece still there ??
i am not sure , out of my head , but the wire to the oil pressure sensor , is either black/red or gray/red
so it does sound like it could be it
i am not sure , out of my head , but the wire to the oil pressure sensor , is either black/red or gray/red
so it does sound like it could be it
Thread
Thread Starter
Forum
Replies
Last Post
immanuel__7
2nd Generation Specific (1986-1992)
89
09-05-15 10:23 AM